First, the advantages of
Stainless Steel Screws.
Screw Series 1. Stronger adaptability. For stainless steel screws, they must meet the requirements of the size of the public thread before they can be used. It can be seen that the use range of stainless steel screws is wider than that of traditional anchor bolts.
widely.
2. The installation is simpler. The traditional anchor bolts in the past are more complicated in the installation process, but today's stainless steel screws are relatively simple in the installation process, which enhances many users.
convenience.
3. There are fewer problems encountered during installation, and there is no need to worry about the inclination of the traditional bolt hole. Through the analysis of the corrosion resistance and fracture of the
Stainless Steel Screw, when installing the stainless steel screw
It can be directly drilled and then installed, so the success rate can reach nearly 100%.
4. The design is novel, this design can ensure that the aesthetics of the stainless steel screw has been greatly enhanced.
5. There is no trouble when not in use, just use stainless steel screws to fill the hole, or remove the excess part, which not only ensures safety, but also is relatively simple, and does not affect the beauty
view.
6. It can ensure that the performance of stainless steel screws is higher during installation, and the use of screws has been greatly improved.
7. It has good corrosion resistance fatigue and wear corrosion performance, and is used in pumps, valves and other equipment under some corrosive medium conditions.
Second, the disadvantages of stainless steel screws
1. Although the initial cost is high and the life cycle cost is low, it is the most economical component solution.
2. Not suitable for long-term storage, not suitable for long-term use of acid solution with high temperature resistance and high production cost, rust reaction (uncertain) After a long time, it will be locked without disassembly and easy to stick.
3. It is easy to slip teeth or break if too much force is applied, and its toughness is worse than that of ordinary iron screws.
